Ice Sphere - Set of 2
- Product Code: MD02470
- Availability: In Stock
-
NZD
$
12.99
- Ex Tax: $11.30
Ice is absolutely better when its huge.
Introducing the perfect ice mold, these clever molds bring the art of slow-melting cocktail ice spheres to your home without the overpriced equipment, and adopt a silicone lid for easy to use molds.
Perfect for whisky or cocktails you don't want watered down by melted ice, the spheres produced by these molds take a very long time to melt, they will still be hanging around long after you've finished your drink.
The molds stack neatly when not in use, and are so easy to use: just add water up to the raised line, and just wait for it to freeze.
As an idea feel free to add a bit of Mint or Lemon to your ice sphere
Features:
- Made from BPA-free plastic and silicone.
- Each mould is approx. 8cm (H) x 8.5cm (W)
- Each ice cube is approx 7cm diameter
- Top rack dishwasher safe
USE:
- Fill molds to raised line, and then gently lower silicone cap in to each mold.
- Freeze for until frozen usually 4 - 6 hours (depending on your freezer's set temp)
- Once frozen remove from freezer and briefly run each mold under warm tap on all sides
- Peel the cap off easily by pulling up on the tabs
- Squeeze side to release ice
Introducing the perfect ice mold, these clever molds bring the art of slow-melting cocktail ice spheres to your home without the overpriced equipment, and adopt a silicone lid for easy to use molds.
Perfect for whisky or cocktails you don't want watered down by melted ice, the spheres produced by these molds take a very long time to melt, they will still be hanging around long after you've finished your drink.
The molds stack neatly when not in use, and are so easy to use: just add water up to the raised line, and just wait for it to freeze.
As an idea feel free to add a bit of Mint or Lemon to your ice sphere
Features:
- Made from BPA-free plastic and silicone.
- Each mould is approx. 8cm (H) x 8.5cm (W)
- Each ice cube is approx 7cm diameter
- Top rack dishwasher safe
USE:
- Fill molds to raised line, and then gently lower silicone cap in to each mold.
- Freeze for until frozen usually 4 - 6 hours (depending on your freezer's set temp)
- Once frozen remove from freezer and briefly run each mold under warm tap on all sides
- Peel the cap off easily by pulling up on the tabs
- Squeeze side to release ice
About
Twitter
Facebook